HOW TO USE ANSR: Acne Care
Recommended usage: One or two treatments per day.
ANSR: PREP Wet face and gently massage the refreshing cleanser into a lather. Leave on your skin for an additional 20 seconds to allow the ingredients to work. If drying of the skin occurs, start by leaving ANSR: Prep on the skin for 5 seconds, and gradually build up to the full 20 second application. Rinse thoroughly and pat skin dry. Avoid eye area when cleansing with PREP.
ANSR: BEAM Once you've thoroughly cleansed your skin, you're ready to apply both BLUE and RED photo light to the affected areas.
BLUE LIGHT: Press the BEAM "ON" button for BLUE LIGHT and place directly on the skin. The BEAM will vibrate slightly to let you know it's working. Using a slow, sweeping motion, gently run the unit along the surface of your skin for 5 minutes.
RED LIGHT: The BEAM will then automatically switch to deep penetrating RED LIGHT waves for 5 minutes. Repeat the same process, gently moving the device back and forth along the skins surface until the BEAM automoatically shuts off. , followed by automatic shut-off. (You can manually cycle from BLUE to RED by switching the button off and then on again.)
ANSR: DAY After treatment with light, apply a layer of DAY lotion to acne prone areas. Gently massage until absorbed into the skin. If drying of the skin occurs, begin with a spot application, and gradually build up to application over the entire afflicted area. You may apply makeup directly following application of ANSR: Day.
ANSR: NIGHT Cleanse skin and treat with light, as in the morning. Apply a layer of NIGHT gel to acne prone areas. Gently massage until absorbed into skin. If drying of the skin occurs, begin with a spot application, and gradually build up to application over the entire afflicted area. You may follow with your choice of moisturizer.
